This article describes how to set up integration between 3.12.5 - Smart ID Identity Manager (PRIME) and physical access control systems (PACS), using the Physical Access component (PACS Backend). 

For a list of supported PACS systems, see Full PACS integration in 3.12.5 - Identity Manager requirements and interoperability. 

Install PACS Backend

First, follow the general instruction needed for all Physical Access use cases: 

• 3.12.5 - Install Physical Access in Identity Manager

For more information on installation requirements, see: 

• 3.12.5 - Physical Access requirements

Set up integrations to PACS systems

When the Physical Access component is installed, integration to specific PACS can be set up:

• 3.12.5 - Set up integration with ASSA ARX
• 3.12.5 - Set up integration with Salto
• 3.12.5 - Set up integration with Bewator 
• 3.12.5 - Set up integration with Bravida Integra 
• 3.12.5 - Set up integration with Security Shells iSecure for connection with HID controllers
• 3.12.5 - Set up integration with RCO R-CARD M5
• 3.12.5 - Set up integration with SiPort 
• 3.12.5 - Set up integration with Unison Pacom