Integrate physical access control system (PACS) with Identity Manager

This article is valid for Smart ID 21.04 and later.

This article describes how to set up integration between Smart ID Identity Manager and physical access control systems (PACS), using the Smart ID Physical Access component.

For a list of supported PACS systems, see section “Supported PACS connectors in Identity Manager” in IDM 23.10.3 - Requirements and interoperability .

Install Physical Access component

First, follow the instructions to deploy the Physical Access component:

Physical Access installation and upgrade

Set up integrations to PACS systems

When the Physical Access component is installed, integration to specific PACS can be set up:

Set up integration with UniLock

Set up integration with Interflex IF-6040

Set up PACS demo service

Set up integration with RCO R-CARD M5

Set up integration with Dorma Kaba Exos

Set up integration with Security Shells iSecure for connection with HID controllers

Set up integration with Unison Pacom

Set up integration with ASSA ARX

Set up integration with Bravida Integra

Set up integration with SiPort

Set up integration with RCO R-CARD M5 Admin API

Set up integration with Salto

Set up integration with SiPass Integrated

Set up integration with Bewator Omnis

Additional information

Useful links

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.