- This line was added.
- This line was removed.
- Formatting was changed.
This article describes how to configure when to start processes on core objects in Smart ID Identity Manager. This can, for example, be used if you have made a card request for a person, then you should not be able to make another card request for the same person until the first is done.
If there is a precondition for a process to start that depends on data from inside Identity Manager, and that data can be found via searches, use the 'Dynamic Search' precondition validator. The symbolic name is
The 'Dynamic Search' precondition validator validates the number of results that are found by a configured search. Depending on if the number matches the condition or not, the required action is triggered.
The 'One Process per CoreObject' precondition validator can be used when there are many operators and you want to make sure that if one operator has started a process, for example a card request for a specific person, that a second operator cannot start a card request for the same person at the same time. You configure in Identity Manager Admin if the process shall be grayed out or not visible at all in Identity Manager Operator.
The symbolic name is
Migrate old StartInterceptors
This section describes how to migrate from the old StartInterceptors to the new configuration.
TypedCoreObjectRelationProcessStartInterceptor & RelatedObjectsInDefinedStateMissingProcessStartInterceptor