Skip to main content
Skip table of contents

Modify token procedure in Certificate Manager

This article describes how to change the parameters of a token procedure within Certificate Authority (CA) in Smart ID Certificate Manager (CM). The task is done in Administrator's workbench (AWB).

The procedure can be closed or reactivated or the card serial number range can be changed. As the same form is used when both creating and modifying token procedures, the descriptions are identical, except that no options are available during this task. It is only in the title bar you can see which command is being executed. See Create token procedure in Certificate Manager.

Related information

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.