Skip to main content
Skip table of contents

Automatically distribute Card SDK configuration

This article describes how to distribute common hardware settings to multiple Nexus Card SDK clients, by using the cms.ini file and silent installation. 

Prerequisites
  • Card SDK installed on one client with Configuration Manager for setting up hardware, see Install Card SDK

Step-by-step instruction

Set up hardware configurations
  1. Set up any needed hardware, for example for printers, readers, encoders, cameras, signature pads. For more information, see Configure Card SDK

    The hardware configuration is stored in the following file: 

    cms.ini file

    XML
    C:\ProgramData\cms\cms.ini
Distribute hardware settings to multiple clients

To distribute the hardware settings to multiple clients:

  1. Copy the cms.ini file to the c:\programData folder for software distribution.
JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.