Skip to main content
Skip table of contents

Create user add-on LDAP

Use case scenario

An operator wants to import a user from LDAP into Identity Manager.

This article describes how an operator creates a user in Smart ID Identity Manager via LDAP connection.


Step-by-step instruction for the operator

Log in to Identity Manager Operator
  1. Log in to Identity Manager Operator with your user account.
Create user add-on LDAP

To create one single user:

  1. In the Quick search drop-down list, select User.
  2. Click Create user Addon LDAP.
    1. You have two possibilities to create the user:
      1. Import by LDAP (User creation via LDAP connection, see step 3).
      2. Manual input (User creation in Identity Manager via editing data, same as in Create user, see step 4).
  3. To create the user via LDAP connection, select Import by LDAP.

    1. Click Next.

      To cancel the process, see "Cancel the process" below.

    2. Click Search to search for an active user in the LDAP directory.

    3. Select the user that you want to import (only single import is possible).
    4. Click OK.
    5. Click Next to import the user data and create the user in Identity Manager.
    6. If the user already exists in Identity Manager, a pop up is shown with information that user already exists. Click Cancel to quit the process or click Try again to go back to the search in the LDAP page.
  4. To instead create the user via manual input, select Manual input.
    1. Click Next.
    2. The same input form as in Create user is shown. Follow the steps in that instruction.
Cancel the process

To cancel the process:

  • Click Cancel to close the process.
  • Click Next to proceed with the process.

Use case details

Overview and technical details
Use case descriptionAs an operator I want to create a new Identity Manager user via an LDAP file
  • End state for user = "active"
  • New user record, created via LDAP connection
  • User information is mapped in the right fields
  • User is assigned the Operator, Approval and Self-Service roles
  • The Source field is filled with the value LDAP
Symbolic name


Process name

Create user Addon LDAP


Identity Manager Operator

Process start

Quick search>User>Create user Addon LDAP

Executable for



There are no options for this use case.

Additional information

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.